HI thanks for giving us a chance to play these old games....just ran into a problem i have never seen before after trying to help a newcomer to Xlink. On Socom CA after you put Manual IP info in...It is now asking for primary and secondary DNS???Wont let you past the screen either. I thought he may be doing something wrong but i tried myself...and same thing....I just setup my Xlink also about a week ago. did not have these problems...how did this change? and if possible...how do i get around this screen.. for you guys that already have a network edited id suggest you back it up...till we figure out what this is about. help would be appreciated.
SgtLegend TX Server Nerd
Joined: 27 Nov 2007
Posts: 5261
Location: Melbourne, AU
Posted:
Wed May 31, 2017 11:58 pm
Hi,
The DNS values can be any valid IP address that allows recursive lookups, in most cases, you only need to enter a single IP which is that of your router and/or modem. Depending on the model of the hardware you have, this can vary but the most common IP's are:
10.0.0.1
192.168.0.1
192.168.1.1
This IP is the same one that gives you access to configure your router or modem. The easiest way to work out which one you need to by looking at another device which will more than likely be using DHCP and have it's DNS assigned automatically.
View next topic View previous topic
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
