Since I have to use a PC, I have my OG Xbox in the office which is on the opposite side of the wall so can't leave a cable connected permanently so I purchased this bridge. For normal network stuff it's been fine and Kai works fine if I run a long cable across the room.
I'm unable to get Kai to recognize the Xbox with the bridge though. I read through the documentation and understand how things work and one of the suggestions/requirements is to clone the bridge MAC onto the Xbox. The only way I can figure out how to attempt trying this is going to the stock MS dashboard and setting it there. My Xbox is modded and once I go to XBMC and back to the MS dashboard, the MAC I put in the Advanced settings is gone.
Is there another/better place to be cloning the MAC on a modded xbox with a different dash?
Is this bridge just incompatible?
Thanks
Maverick0984 Kai Beginner
Joined: 10 Nov 2004
Posts: 4
Posted:
Fri Sep 14, 2018 1:24 pm
So after more reading, I need to be able to somehow get the Xbox MAC on the layer 2 network which it is currently not because the bridge is segmenting things into layer 3's (IP only) and making my PC only see the MAC of the bridge.
It doesn't look like this bridge allows MAC spoofing so I might be SOL.
Maverick0984 Kai Beginner
Joined: 10 Nov 2004
Posts: 4
Posted:
Sun Sep 16, 2018 4:55 pm
Ended up using a RPi 2B for this and it seems to be working well.
View next topic View previous topic
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
