RGH console first time set-up

Kai Beginner Joined: 02 Feb 2012 Posts: 2

Hi,

I am attempting to set-up XLink for the first time on my glitched xbox 360, I have run into some problems and would appreciate some advice to get up and running.

Details on my config and error messages I am receiving are outlined below, if you require further information please let me know and I will update the post.

Cheers, Mirtna

PC config: -
>Windows 7 x64
>Connected to router via network switch and ethernet cable
>Instaled XLink Kia 7.4
>Set-up a static IP address for my PC running the xlink kia engine
>Configured port forwarding to 30000
>I am running Windows Firewall but have tried turning it off when testing with no success

Xbox 360 config: -
>RGH console running FSD 2.2
>Connected to router via network switch and ethernet cable
>Set-up a static IP which is listed as connected via ethernet by my router

XLink Kia setting: -
>Reachable = Yes
>The MAC address for the console is listed but it states that it is a PSP not an Xbox 360

Xbox 360 error: -
>When I attempt to login to XLink Kia through the FSD, I receive the following error message: -

"Live Status: XLink engine not found on network..."

XLink error (happens occasionally)
>The following error message appears on occasion, when I refresh my browser XLink appears to connect to orbital: -

"Communications between the UI engine appear to have stopped responding. Is the engine still running? Refresh your web browser to proceed."

Kai Beginner Joined: 02 Feb 2012 Posts: 2

Anyone?

Kai Beginner Joined: 19 Feb 2012 Posts: 1

i know its been 17 days since you asked, but i just joined today, and seen your post.
try going to the xlink kai configuration on your pc, and click the box that says allow remote ui connections.