yesterday the bridge was doing fine but now whenever i double click it.. this appears!!! what should i do??
giggyprince Team XLink Moderator
Joined: 27 Feb 2011
Posts: 1206
Posted:
Tue Sep 18, 2012 12:55 pm
You have to install WinPcap, after you've installed it go to your kai config and set WinPcap as packet capture engine.
olong Kai Beginner
Joined: 08 Sep 2012
Posts: 8
Posted:
Tue Sep 18, 2012 1:52 pm
I've installed it yesterday and i played with other players but now i doesn't even work
giggyprince Team XLink Moderator
Joined: 27 Feb 2011
Posts: 1206
Posted:
Tue Sep 18, 2012 3:32 pm
Why do you use singlethread2 in bridge ??? Use multithread.
Bridge says its not installed. To test if WinPcap is running, click on the Start button and then on run. Type msinfo32. The System Information panel will show up. Choose Software Environment, then System Drivers. The entry NPF should appear there. If you launched a WinPcap application previously, the state should be running.
View next topic View previous topic
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum